I have a customer who has specified +/-1 degrees on angles in the
general tolerance portion of their part number title block on their
blueprint. On other prints the typical tolerances found are +/5 degrees.
Is this +/-1 degrees something that's possible?
What on earth could measure something like that?
Is their a general specification that lists volume/production tolerances
including something like these angles?
I'm extremely curious,
David Hoover
Staff Application Engineer
Multek Technology, Inc.
www.multek.com
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------