Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 31 Jul 2002 14:10:13 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Steve,
It seems more likely that your assembler is making this request in order to
reduce shorting between adjacent chip components, not shorts between two
pads of a single component. When exposed to wave solder, adjacent chip
components can often short together if there is not enough spacing between
them. A minimum of .040" is usually optimal. Also depends on board
orientation relative to the wave.
I suppose a line of silkscreen between the chips may help also, but I've
never seen this.
Regards, Dave
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|