Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 16 Jul 2002 14:10:32 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hey Mike,
Try Delrin.
In a previous life it served well for Bed-o-Nail plates on all our
functional testers.
ESD was not a big issue for us except on ASICs and we had no problems I can
remember.
Hope it helps,
FNK
Frank N Kimmey, C.I.D.+
Senior PCB Designer
Powerwave Technologies
PH. 916-941-3159
Fax 916-941-3195
-----Original Message-----
From: Michael Bell [mailto:[log in to unmask]]
Sent: Tuesday, July 16, 2002 1:15 PM
To: [log in to unmask]
Subject: [TN] Test/Pin Jig Materials
Hi all,
I am just looking into the best material in which to make the main plate of
a pin bed test jig. I am wanting some insulative plastic, but I am a
little concerned over the static properties of most plastics/acrylics. Does
anyone have any idea on the best type of plastic/acrylic/urethane etc to use
in this application to minimise the static risk, or is there an anti-static
plastic about that I can purchase in large blocks for milling???
Cheers
Mike
----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|