I wonder if some experts could refresh my memory on some PCB tolerances assuming materials and processes
suitable for very high volume commercial quality PCB's.
Imagine I have a rectangular board about 50 X 100 mm (2"X4") with four fixing holes - one in each corner
and a set of pads somewhere in the middle of the board. Here's the features I'd like tols on:
The tolerance on the fixing hole diameter.
The tolerance on the position of the pad pattern to the fixing hole.
The tolerance between individual pads in the pattern - assume each pad is 1mm wide by 2mm long.
Thanks,
--
Eric Christison
Mechanical Engineer
STMicroelectronics
33 Pinkhill
Edinburgh
EH12 7BF
Tel: (0)131 336 6165
Fax: (0)131 336 6001
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------