Steve,

I referred to this as an "assault with a deadly weapon" on the boards!

David A. Douthit
Manager
LoCan LLC

"Sauer, Steven T." wrote:

> Good Morning Carl,
> For starters I would like to say, "Good question, this is going to spread
> hysteria throughout Technet land!"  This reminds me of the good 'ol days
> providing clarifications and interpretations of mil specs/std that was
> somewhat entertaining.
> IMHO -- you are correct in your interpretation that the noted exception on
> page 6-7 applices to class 2 & 3 (also note that this page conflicts with
> table 6-2 Class 2 that states that 75% hole fill is required while 6-7
> states 50% is acceptable).  BUT, the user must ensure that this is
> acceptable for the intended use environment and all the 'ilities are
> unaffected.  I would much rather accept 50% hole fill any day than to
> perform touch-up -- oh the joint looks better now, but seriously let's look
> at what damage has been done to innerlayer interconnections (oh, we can't
> see that so it must be okay).
> Have a nice day!
>
> Steve Sauer
> Northrop Grumman, Xetron
>
> -----Original Message-----
> From: [log in to unmask] [mailto:[log in to unmask]]
> Sent: Thursday, May 09, 2002 2:44 PM
> To: [log in to unmask]
> Subject: [TN] PTH Vertical Fill Requirement IPC610 Rev. C
>
>                 Hello,
>
> Looking for the groups opinion(s) on the vertical fill requirement stated on
> page 6-7 of IPC-A-610C.
>
> Is the exception pertaining to the Defect Class 3?
>
> ---------------------------------------------------------------------------------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
> To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
> ---------------------------------------------------------------------------------

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------