Dave
Are you sure Doug didn't lace your Coke with Mountain Dew?
Brian
Dave Hillman wrote:
>
> Hi folks! I have ran into a problem which has me baffled and the extra 20
> ounces of Coke I consumed this morning didn't bring about any better
> thought clarity so I would like to bounce the problem off the minds of
> TechNet. I have been attempting to hand solder a chip resistor (50 x 100)
> but have immediate cracking of the resistor across the width of the
> component. The resistor is either Aluminum Nitride or BeO (I'm still trying
> to find out which material). And yes, we are using proper soldering
> technique(s) and the resistor pad geometries are our standard dimensions. I
> know that the typical resistor body material is Alumina. Has anyone had
> good or bad experiences in hand soldering AlN or BeO resistors? Have I run
> into a material flexural strength issue?
>
> Dave Hillman
> Rockwell Collins
> [log in to unmask]
>
> ---------------------------------------------------------------------------------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
> To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
> ---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
