I am a newbie to the SMT world and would appreciate some assistance on a
question that came up this afternoon. I hope I get the question right; I
used to build rockets.

One of our customers wanted to know if we had any experience re: which is
better - a in-line 5DX-to-FCT process or an ICT-to-FCT process. Not a lot of
response around the table from the more experience hands. I assume "which is
better" means which process is a more efficient inspection setup for
locating nonconformances.

Would appreciate any comments. Now if you would excuse me, I am going out on
the floor to find a 5DX and figure out what the devil that is.

Ben Royal

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------