Dee,

For the so-called Augat "Holtite", either .041 +/-.002 or 058 +/-.002,
per:

http://www.aboveboardelectronics.com/thomasandbetts/pdf/au_sockets/sip_H
oltite.pdf

However, be sure to consult the assembler for verification of this hole
size. In my experience, more than one assembler chose to permutate the
parameters for optimal use of the so-called "shake fixture" onto which
your board will be laid, and into which said "Holtites" may be gang
shaken.  I was told to use .041 +000/-.002 by one of these folks.  Good
luck!

Gary

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------