Hello all,

Maybe this is a strange question but there are very much absoletb components
to be placed on the boards.

I like to know if there is a test method on testing MLB boards for
delamination.

I have been thincking about placing the boards into a oven for a while
before soldering the boards. What time should i use in the oven and at what
temperature to be sure there will be no delamination.

The soldermethode for these boards is 2 x reflow an 1 x wave.

Best regards,

Gerard Goossens
Flatfield multi print
Tel  :+31-344-622556
Fax :+31-344 613652

-----------------------------------
Mail  : [log in to unmask]
Website : www.flatfield.nl
-----------------------------------

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------