Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 4 Oct 2001 09:59:34 +0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In former life, whenever we swaged connector pins, we soldered them as
well. This was done partly as extra mechanical support, partly to make a
"proper" chemical electrical contact as opposed to a purely mechanical one,
which can be high resistance, and partly as corrosion protection.
Peter Duncan
Chris Stack
<cstack@DBTRO To: [log in to unmask]
NICS.COM> cc: (bcc: DUNCAN Peter/Asst Prin Engr/ST
Sent by: Aero/ST Group)
TechNet Subject: [TN] pin swaging - soldering still
<[log in to unmask] required?
ORG>
10/04/01
02:36 AM
Please
respond to
"TechNet
E-Mail
Forum."
I need some advice about swaging connector pins. After they are swaged, is
soldering still neccessary or will clamping down on the pad make an
acceptable solder joint? The circuits they will be in are in the 450MHz -
1GHz range.
Thanks For your help.
Chris
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
---------------------------------------------------------------------------------
[This e-mail is confidential and may also be privileged. If you are not the
intended recipient, please delete it and notify us immediately; you should
not copy or use it for any purpose, nor disclose its contents to any other
person. Thank you.]
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|