>>> <[log in to unmask]> 09/17/01 03:31PM >>>
Expert on manufacturing, the need for or using? What is your application? I
always (luckily) ended up on using paste-in-hole or hand solder because
preforms are hard to use in high-qty, mass production and preform providers
are sometimes difficult to get samples from to experiment with. Indium was
nice about getting me some samples in a timely manner. 

Dorothy Lush

> ----------
> From:         Jack Crawford[SMTP:[log in to unmask]] 
> Reply To:     TechNet E-Mail Forum.
> Sent:         Monday, September 17, 2001 10:10 AM
> To:   [log in to unmask] 
> Subject:      Solder Preforms ?
> 
> >>> Barry Gallegos 09/17/01 12:02PM >>">[log in to unmask]>
> 09/17/01 12:02PM >>
> Are there any Solder Preform specialists out there.
> 
> Barry Gallegos
> Process Engineer
> Western Electronics
> 1550 South Tech Lane
> Meridian, Idaho 83642
> Phone: 208/955-9771
> Fax: 208/955-9755
> 
> 
> 

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------