Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 7 Aug 2001 13:52:02 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I asked around here and the word was that both Fuji and Hover-Davis should
make a deep enough feeder but Hover-Davis will be less expensive. (He had
seen an 800 mil deep feeder.) A shorter nozzle might be needed and an
adjustment in the pick&place program to give you a rotation for a horizontal
transfer and another rotation to a (normal) vertical placement.
Dorothy
> ----------
> From: Tempea, Ioan[SMTP:[log in to unmask]]
> Reply To: TechNet E-Mail Forum.;Tempea, Ioan
> Sent: Tuesday, August 07, 2001 12:08 PM
> To: [log in to unmask]
> Subject: Fuji IP3 feeders
>
> Hello again,
>
> this is for the ones suffering in the contract manufacturing world due to
> the high flexibility we need.
>
> The problem is that I have a .500" high part in a 44mm wide tape and the
> feeders available from Fuji and Hover-Davis can only accomodate parts
> .400"
> high, at best. I spent all the morning to figure out if I could mill the
> feeder. No way!
>
> So the question is: does anybody know of other sources of Fuji IP3 feeders
> that make what I need.
>
> Many thanks,
> Ioan
>
> --------------------------------------------------------------------------
> -------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt delivery of Technet send the following message: SET
> Technet NOMAIL
> Search previous postings at: www.ipc.org > On-Line Resources & Databases >
> E-mail Archives
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
> additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
> ext.5315
> --------------------------------------------------------------------------
> -------
>
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|