Good Morning.

As part of a design mod, I have been requested to remove 2 Through Hole
resistors from one of our assemblies. There are @2000 boards.

What is the recommended process for removing Through Hole capacitors. Is
there any IPC guidelines?

I would like to just clip the leads on the top and bottom of the board for
an easy rework.  This will leave part of the leads soldered in the holes,
but I am not aware of any issue with this apart from the fact it may not
look pretty!

Any advice would be much appreciated.

Thanks again,
John

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------