Good Morning.

I'd like to get some input on what type of equipment some of you
experienced folks have used to depanel PCB's.

I have used Hydraulic punch press and Pizza cutter type equipment
previously, but am looking for any other viable options to depanel a 16 up
panel to individual boards.

Our CM currently break these by hand after assembly(fortunately it is a
thick fab,)and we are looking to purchase a pizza cutter again, but I would
like to investigate any other options.

What are your experiences and suggestions.

Thankful as always for your advice.

JF

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------