Content-Type: |
text/plain; charset="iso-8859-1" |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Tue, 24 Jul 2001 10:13:37 -0700 |
MIME-Version: |
1.0 |
X-To: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
He could have just said one ounce per square inch. (Close enough!) Seems
easier to remember than 4.65 g/cm2. But eventually you're going to end up
doing some arithmetic, either way.
Tim Reeves
-----Original Message-----
From: Eric Christison [mailto:[log in to unmask]]
Sent: Monday, July 23, 2001 8:44 AM
Subject: Re: Component Mass / Pad Geometries
Nice to see some consistent units - g/in^2 here. Haven't seen this mix since
I came across a stress quoted in N/in^2 ;-).....
> Hi Steve!
>
> The formula that has been floating around for a while is that you get
> 30-grams of surface tension for every square inch of pad surface....
>
> -Steve Gregory-
>
>
> > Question?
> >
> > There is a formula somewhere which I can use to calculate the maximum
> > allowable mass of a component in relation to the pad lands. Basically
> I
> > want to make sure our designers do not put components on the underside
> > of the PCB which are going to fall off during doublesided reflow.
> >
> > I would like to point out that this is a design for manufacturability
> > question, not an attack on the tentative grasp on reality some card
> > designers have.
> >
> > Steve.
> >
>
>
>
Eric Christison
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|