Hi all,
We need to pack all the components as close to each other as possible onto
both sides of the board. Please share your knowledge on how to determine the
minimum spacing for a manufacturable design. Please give feed back to the
spacings(attached table in inches)we are using. Please tell me which ones
can go tighter?!
Thanks,
Patrick Lam
Phone:(604)293.4392
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------