Hello,
At this day I was asked by our engineer if it is possible to put a
additional silk-screen onto the board.
This additional silk-screen has to be in a different color than the
board and the normal one. Even it should have the same clearance and
minimal line width requirements as a Solder Mask. For this it must be a
photoimageable process.
What would you say to this issue ?
Is it possible to run a second "SolderMaskProcess" with a different Mask
and color and how much would it cost on your opinion ?
Regards,
Florian Pitzl
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------