Hi, Patrick,
As you've probably gathered by now, TechNet doesn't accept attachments, so
I cannot look at your table. I'm also no active PCB designer, only a
passive one, looking over the shoulders of others. However, population
density of a board depends on a number of factors that include:
Board material and dielectric thickness
Power running through the board
Signal separation requirements
In circuit testing (this takes up a lot of real estate on a board since
you have to have a test pad for every net plus pull-up or pull-down
resistors to isolate IC's for testing plus a minimum pad size and
spacing to permit access to the test pads by the test jig probes). If
you can carry out simulator testing using a Test Access Connector or the
I/O connectors instead of ICT, then I recommend that for space saving.
Many people like to use Leadless Chip Carriers or BGA's, etc., as a
means of saving space on a card - you don't have all those leads
sticking out and taking up space. You should, though, be aware of the
Co-efficient of Thermal Expansion (CTE) differences between these
components and the board material and the problems this causes, should
you choose to go down that route.
Avoid having too much tracking on the outer layers. There is a
compromise to be reached between surface tracking, the number of via
holes and the number of layers you need to have, but surface tracking
also takes up a lot of space.
If you're building conduction-cooled boards, you may have large lock-out
(aka keep-out) areas on the card surface for heatsinks/conductors and
thermal via hole features that limit tracking area and component
placement positons.
Hope this helps a bit. There are plenty of PCB gurus on TN who can give you
more detail.
Pete Duncan
"Lam, Patrick"
<Patrick.Lam@GLE To: [log in to unmask]
NAYRE.COM> cc:
Sent by: TechNet Subject: [TN] Minimum Spacing For SMD
<[log in to unmask]
>
04/25/01 12:25
AM
Please respond
to "TechNet
E-Mail Forum.";
Please respond
to "Lam,
Patrick"
Hi all,
We need to pack all the components as close to each other as possible onto
both sides of the board. Please share your knowledge on how to determine
the
minimum spacing for a manufacturable design. Please give feed back to the
spacings(attached table in inches)we are using. Please tell me which ones
can go tighter?!
Thanks,
Patrick Lam
Phone:(604)293.4392
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|