Iain

Provided you have good solderability on both sides and a correctly
adjusted machine, you will have no problems IMHO. I've done much finer
than this. However, if you have wetting problems (including dewetting),
then you're in it, deep!

Brian

Iain Braddock wrote:
>
> Techo's,
>
> I am interested to know if anyone (perhaps one for you Steve!) has any
> experience with soldering fine line thru' hole connectors.
> We currently have a design challenge/opportunity that will require micro
> 'D' type connectors in 0.05" pitch.  We are about to conduct an exercise
> evaluating this but am interested if anyone has succeeded in this.
>
> We currently use a Soltec 6522cc which has the luxury of N2 at the point
> of wave break.
>
> Iain.
>
> ********************************************************************
> This email and any attachments are confidential to the intended
> recipient and may also be privileged. If you are not the intended
> recipient please delete it from your system and notify the sender
> immediately by telephoning +44(1252) 373232. You should not copy it
> or use it for any purpose nor disclose or distribute its contents to
> any other person.
> ********************************************************************
>
> ---------------------------------------------------------------------------------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
> Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
> ---------------------------------------------------------------------------------

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------