I have seen these type parts wave soldered succesfully. It was not too
difficult to get the setup right, good flux, good preheat, and careful
adjustment of the wave. We did not have N2.

 Guy Ramsey
American Competitiveness Institute
Senior Lab Technician / Instructor
610 362-1200 ext 107


-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Iain Braddock
Sent: Tuesday, March 27, 2001 6:27 AM
To: [log in to unmask]
Subject: [TN] Mission impossible or is it?


Techo's,

I am interested to know if anyone (perhaps one for you Steve!) has any
experience with soldering fine line thru' hole connectors.
We currently have a design challenge/opportunity that will require micro
'D' type connectors in 0.05" pitch.  We are about to conduct an exercise
evaluating this but am interested if anyone has succeeded in this.

We currently use a Soltec 6522cc which has the luxury of N2 at the point
of wave break.



Iain.




********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender
immediately by telephoning +44(1252) 373232. You should not copy it
or use it for any purpose nor disclose or distribute its contents to
any other person.
********************************************************************

----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------