Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 21 Feb 2001 11:40:42 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
With a reasonably competent operator and well-maintained spindles, you
should able to +/-.005 easily. We do all the time, actually, it's our
default when no tolerance is supplied.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of John Parsons
Sent: Wednesday, February 21, 2001 11:16
To: [log in to unmask]
Subject: Re: [TN] FAB - Reality Check, Tooling Holes and Profiling
Steve,
And with pinless routs you are having no problems maintaining the
+/- 0.005" tolerances seen on many of todays fab drawings? Or do
you not see tolerances spec'd this tight?
Regards
John Parsons
> John, we use pinless routing with '80s vintage Excellon Mark IV's. A lot
of
> today's designs don't leave a lot of room for additional tooling, and
> pinless saves on set-ups.
----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|