Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 16 Feb 2001 07:44:07 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Depends, in a production environment, on assemblies with BGA, or high pin
counts, or for use when area / aspect ratios are difficult absolutly do not
reuse paste. Steve is right it will bite you.
In prototype environments, very low volume, on assemblies with large stencil
apatures, or where you anticipate a lot of inspection, board evaluation,
test, go ahead. You probably will not notice the difference.
Guy Ramsey
American Competitiveness Institute
Senior Lab Technician / Instructor
610 362-1200 ext 107
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Nicolas Ortiz
Sent: Thursday, February 15, 2001 9:41 PM
To: [log in to unmask]
Subject: [TN] Solder paste reuse
Solder paste reuse: does anybody has this practice? Obviously, my solder
paste supplier does not recommend it.
Nicolas Ortiz
Process Engineering Group Leader
Conexant Systems
----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|