Have you consulted the Universal Radial Design Guidelines manual



                    Simon Howells
                    <showells@BLUEGUMTE        To:     [log in to unmask]
                    CH.COM.AU>                 cc:
                    Sent by: TechNet           Subject:     [TN] PCB Design for Radial Insertion
                    <[log in to unmask]>


                    01/09/01 03:28 PM
                    Please respond to
                    "TechNet E-Mail
                    Forum."; Please
                    respond to showells






Hi All,

Does anyone know of some PCB design guidelines for boards that use radial
insertion, eg; clearance insertion paths etc.
The machines that we will use are older Universal Rad "2" 5.04mm component
pitch
inserters.

The reason for this is we are reviewing a design that uses radial insertion
topside, surface mount bottom side and wave soldering.

Any help would be greatly appreciated.

Thanks.

Regards,
Simon Howells
Senior NPI Project Engineer
Solectron Telecommunications Pty Ltd,
Tel.   02 8778 1687    Mob. 0418 400 394    Fax. 02 8778 1555

Email:     mailto:[log in to unmask]
Web:  http://www.solectron.com

---------------------------------------------------------------------------------

Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
---------------------------------------------------------------------------------

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------