If you raise your head and look to the east you will find the solution for
your problem.
Kent

-----Original Message-----
From: Franklin D Asbell [mailto:[log in to unmask]]
Sent: den 31 oktober 2000 14:17
To: [log in to unmask]
Subject: Re: [TN] Critical question via plugging- Does need to apply
from bothsides?


Ken,

Depending on the application, plugging only one side of a via may work
well. Often with BGA and similar design the preferred method is to plug
top and bottom.

It's really not difficult to do. A method we prefer is to plug one side
and ensure (bake or added cure) no moisture (either water or chemical)
is entrapped in the opposite exposed via. The repeat the process with
the opposite side of the board. We use an automatic screen coater on the
majority of work we perform, for this type coating we do it the old
fashion way...by hand. Screening by hand, especially the second coat
allows us to the mask in a way as to ensure complete filling of the via.
If you don't completely fill the via there is a good chance the gas
trapped in the void will expand viol;ently in subsequent thermal
processes.

Hope this helps.

Franklin

Ken Patel wrote:
>
> Fab experts,
> After getting few responses on my previous email on via plugging, I was
> surprise to find one response saying that plugging of the via is not going
> to fill the via complete but it will rather be towards the side it
applied.
>
> So, the question is that then there is a possibility of chemical
entrapment
> from the other side so do I have to tell the fab house to plug it from
both
> sides?
>
> re,
> ken patel
>
>
----------------------------------------------------------------------------
-----
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
>
----------------------------------------------------------------------------
-----

----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------