Does anyone out there have experience in designing apertures for D type
pads that incorporates a via within it. The pads are for a 1206 resistor.
Our current design is a circle which is offset from the front of the pad to
eliminate solder balls, he foil thickness is 0.005" ( due to other fine
pitch devices on the assembly . The solder fillet resulting from our
current aperture design is just passable, but is definately bordering
insufficient, due to the solder running down the via. Any help or advice on
the following questions would be greatly appreciated:

1. How do I calculate how much solder volume ie required for a type of pad
that incorporates a via hole within it ?

2. Can I over-print onto the solder mask ?

3. What other aperture designs are available for this type of pad ?

Sal.

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------