OK, this is kind of a simple question....
We have been using .125 tooling holes for quite awhile,
but just discovered our Fuji machines use 3mm pins.

There was some discussion about what size tooling
hole is "best", so I figured I would ask you guys.
(what size in decimal with WHAT TOLERANCE?)

Jack (still the new guy, it seems)

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------