Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 28 Sep 2000 19:56:07 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Mike,
Standardized hole spacing and hole diameter relative to lead diameter is
essential for good operation on a CS400. These changes have made a huge
difference in our assembly operation.
Phil Nutting
-----Original Message-----
From: Mike Sewell [mailto:[log in to unmask]]
Sent: Thursday, September 28, 2000 4:57 PM
To: [log in to unmask]
Subject: Re: [TN] Lead Clinching over soldermask
We have gone to a partial clinch already... and shortened lead protrusion to
~ 50 thou. this has helped but hasn't eliminated the problem. I think we'
may be bending leads during handling as this board goes through axial,
CS400,
masking, hand stuff after DIP and prior to wave. Plus we still have the
axial & CS400 parts that may get clinched towards a trace - we've tried to
tweak to partial clinches there as well. 600 - 700 parts on the board
THOUSANDS of leads, poor spacing, undersized holes/oversized parts, another
board where DFM wasn't exercised...
- Mike -
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|