My company is a manufacturer of oscillators and I have some questions
regarding appropriate pad/lead layout.  I am not a design engineer and seek
advice.  Attached is a copy of the proposed layout.  Given the small
dimensions and the spacing between solder areas, there is concern of
problems with manufacturability.  I have two questions:  1.) Does anyone see
any issues with this current layout and 2.) If the 0.600 dimension (penciled
in by hand) is shortened to any degree, would this be a problem?  Please
advise, thank you.

 <<PadLayout.bmp>>
Regards,
Mark Gilbert, Product/Process Engineer
FOX Electronics
For Frequency Control Solutions. . . Fast:
1-888-GET2FOX, ext. 289
Fax: 941-693-1554

http://www.foxonline.com/ <http://www.foxonline.com/>

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################