In a message dated 09/19/2000 6:20:19 PM Central Daylight Time,
[log in to unmask] writes:
> Hi,
>
> I'm looking for manual or semi-automatic de-paneling equipment. We're
> primarily doing low to medium volumes of panelized boards, both scored and
> routed. What vendors make this type of equipment? Any pros or cons I
> should consider (offline if it's vendor specific)?
>
> Thanks in advance.
>
> Rick Thompson
> Ventura Electronics Assembly
> 2665A Park Center Dr.
> Simi Valley, CA 93065
Hi Rick!
Go to:
http://www.fknsystek.com/hot_list_for%20Depans.htm
There's a "Board Nibbler" they make that I've used before for tab/routed
panels that works pretty good. They've got lots of different models of
circular blade depanelers for scored panels as well...
-Steve Gregory-
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################