Hello Fellow Tech net Friends

Question: If a finished thickness of a multi-layer board is stated on a
drawing but there is no tolerance what is the IPC standard
and were can I find that spec.  I was to understand that the tolerance was
+/- 10% of the finished thickness.

William W. DeCray III
Waytec Electronics Corp
Sales Engineer
PHONE:(804) 237-6391 ext 115
FAX:    (804) 237-1324
E-mail:<[log in to unmask]>
Web <http://www.waytec.com>
FTP <ftp://ftp.waytec.com>

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################