Hello,
I will be performing a study on the temperature profile design in the
reflow ovens (forced convection) of our SMT lines. Currently they are
set up in the traditional 4 zone profile (soak zone included.)
Has anyone switched to a 'ramp profile' (eliminated the soak zone) ?
What were the benefits seen with this new profile design?
What is the general opinion in regard to using a ramp profile?
Thanks!
Kate Bishop
Process Engineering
Leitch Technology Int.
[log in to unmask] <mailto:[log in to unmask]>
(416) 445-9640 x. 3395
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################