To all 'netters:

Making a long story short, I have a board where some solder mask has peeled
off.  The board vendor sent me some SR1000 solder mask to touch up the
boards. The spec for the stuff says that the material must be cured at 300F
for 60 minutes.

Since I'm having a h*** of a time getting tech support on this stuff, does
anyone know if this material can be cured at a lower temperature?

Thanks,
Bill Kasprzak
Moog Inc.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################