There is some concern within our organization about possible repetitive
strain injuries occurring with employees who are trimming large quantities
of leads, using manual lead trimmers.  The leads we are trimming are up to
approximately 0.06".

Initially, we were hoping to purchase electric trimmers, but I have had next
to no luck locating electric tools.  I have found a couple of pneumatic
tools that will do the job, but we are hesitant to introduce the air lines
to the floor (cost, safety).  The pneumatic air lines also seem to be more
cumbersome than the electric cords, making it more difficult to maneuver the
jaws of the tool through tighter spaces.

Currently, it's looking like we may be forced to go pneumatic, or stick with
our manual trimmers at this point.

Does anyone have any past experiences (good or bad) with pneumatic or
electric or any related injuries that they would like to pass along?

Any input will be greatly appreciated!

Amanda

Amanda Mountain
Process Engineering
Leitch Technology International Inc.
Phone: (416) 445-9640 ext. 3852
Fax:  (416) 445-7927
http://www.leitch.com/

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################