Gary

I put something onto the web for general consumption if you are wanting to
selectively solder (i.e. mask all solder side smt comps). You can get this
on http://www.datumdynamics.com

Hope this helps

Regards

Fin

Finlay Buchan
Technical Director
Datum Dynamics
Phone +44 (0)1290 426200
Fax +44 (0)1290 426212


-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Smith, Gary
Sent: 10 August 2000 19:21
To: [log in to unmask]
Subject: [TN] Component distances for wave soldering


Hello all,

Trying to get some info or reference sites for suggested distances between
components for wave soldering depending on their orientation to the wave.

I know that if they are facing the wave on the short side of the component
with the leads on the sides the components can be put closer together.  The
question is, what are the recommended distances?

I found an acrobat reader document on the web, but the distances are
unreadable.

Thanks,

-Gary

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################