I'm trying to establish some basic guidelines for the baking of bare PCB's
that have potentially absorbed moisture due to unknown storage conditions
and time.  Are there any industry guidelines for this type of process or
would someone mind sharing their general procedures?  I thought I had read
somewhere about times in the 2-8 hour range at 125 C but can't find that
information anywhere.

Thanks in advance.

Rick Thompson
Ventura Electronics Assembly
2665A Park Center Dr.
Simi Valley, CA 93065

+1 (805) 584-9858 voice
+1 (805) 584-1529 fax
[log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################