yes

-----Original Message-----
From: Barbara Burcham [mailto:[log in to unmask]]
Sent: Thursday, July 27, 2000 7:42 AM
To: [log in to unmask]
Subject: [TN] Assy Question about pin length through the board....Y'all


Technet:

    We have a 0.125 +/- 10% thick backplane board stuffed with connectors
with 3 rows of pins @ 0.512 long.
The length is too long and we would like to use the next shortest length
which is 0.157.
The question: Is the 0.157 pin long enough to have a good solder joint if
the board is at MMC of 0.137 - allowing the pin to come through
the board only 0.020?
We are using 63/37 solder.

Thanks,
Barbara Burcham
In Texas, Y'all

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################