I know there was some discussion here awhile back on intrusive reflow
(paste-in-hole) but I haven't been able to get into the archives to check.
Basically, we have a customer who wants to place a DB-25 connector and some
.100" pitch headers on a surface mount assembly. Does anyone have any
experiences, recommendations, etc. they'd care to share on this process,
especially if it's with the type of parts mentioned?  Any good references or
other places I can look for this type of information?

Thanks,


Rick Thompson
Ventura Electronics Assembly
2665A Park Center Dr.
Simi Valley, CA 93065

+1 (805) 584-9858 voice
+1 (805) 584-1529 fax
[log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################