Hi all,

Our manufacturing plant has a pick and place file which I believe was
created using Cadstar. The rotations given for the parts are 0,1,2 and 3.
My questions are: what angles to these numbers correspond to, and is the
rotation clockwise or anti-clock wise? They don't have a bare board to hand
at the moment, so any advice would be most appreciated.

Best regards,

Mark.

Mark Holmes PCB Designer
Helvar Merca Ltd.
Hawley Mill, Hawley Road,
Dartford Kent. DA2 7SY
Tel: 01322 22 22 11
Fax: 01322 282 286
mailto:[log in to unmask]
http://www.helvar.com

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################