Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 27 Jun 2000 16:21:12 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Steve,
If what you quote from the web site says .019" then that is different from
what Bill and I have. I have it here with me if you want I could look up the
specs that I spoke of in my email where it states .014" over.
Richard Hamilton
Clemar Mfg. / Rain Bird
[log in to unmask]
> -----Original Message-----
> From: Stephen R. Gregory [SMTP:[log in to unmask]]
> Sent: Tuesday, June 27, 2000 4:08 PM
> To: [log in to unmask]
> Subject: Re: [TN] Auto-insertion lead-to-hole ratios...
>
> In a message dated 06/27/2000 6:00:12 PM Central Daylight Time,
> [log in to unmask] writes:
>
> > Hi Steve, I believe Universal published a guide for axial and radial
> > insertion using their machines back in the 1970's and 80's... I had to
> use
> > it to do my boards from back then... Do you have access to that
> > documentation? If not, I will look for it in my archives at home...
> > - Bill Brooks
> >
> >
> > Bill Brooks
> > Senior PCB Designer - [log in to unmask]
> <mailto:[log in to unmask]>
> >
> > Zoneworx, Inc.
> > 40925 County Center Drive, STE 200
> > Temecula, CA 92591
> > http://www.zoneworx.com <http://www.zoneworx.com>
> > Tel: (909) 296-1226 x 1037
> > Co-Director / Education Officer / Webmaster
> > for the San Diego Chapter of the IPC Designers Council
> > http://www.ipc.org/SanDiego/index.html
> > <http://www.ipc.org/SanDiego/index.html>
>
> Hi Bill!
>
> Yeah, I got that...it's on their web page in an Adobe Acrobat file. They
> say
> you should have a .019" +/- .003" larger hole than the lead diameter. What
> I
> was trying to learn is if anybody has tried to push those limits and what
> success they've had. Just so I can put to rest the notion of trying to run
> this board on the VCD...
>
> Thanks!
>
> -Steve Gregory-
>
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|