Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 22 Jun 2000 09:54:21 -0700 |
Content-Type: |
text/plain; charset="us-ascii" |
Reply-To: |
|
Parts/Attachments: |
|
|
We have found some internal fab defect (cracking at one of the inner layer)
which we don't know is due to assembly process or fab process induced.
If I were to create a Thermal shock profile to precipitate defect on a
loaded board How can I come out with? I have decided to use -10C to +70C, 10
minutes soaks, +/-20C/minute ramps, 12 cycles which will give a test
duration approx. 3.6 hours.
Any comments will be highly appreciated. All the failed one were found
during ICT testing hence decided to send all lot.
re,
Ken Patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
1708 McCarthy Blvd. Fax: (408) 490-6859
Milpitas, CA 95035
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|