Jerry:  One example: defibrillator boards must be conformal coated, or you find that
you wasted money having traces etched on the board.  Good luck.  Dave Fish

Jerry Mosur wrote:

> Hi,
>
> I am looking for solder mask material that would reduce voltage creepage
> across the surface of the PCB. We are routinely designing boards with few kV
> across component's pads. The only solution is to route the board between
> pads and as we reach higher levels, route and pot the whole assembly.
> Any info, leads would be appreciated.
>
> Regards,
>
> Jerry Mosur
> Spellman High Voltage
>
> ##############################################################
> TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
> ##############################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
> the body:
> To subscribe:   SUBSCRIBE TECHNET <your full name>
> To unsubscribe:   SIGNOFF TECHNET
> ##############################################################
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
> information.
> If you need assistance - contact Keach Sasamori at [log in to unmask] or
> 847-509-9700 ext.5315
> ##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################