hi,

in our application, the critical parameters are hole size and plating types and thicknesses.  the vendor for the compliant pin has no unusual requirements for things such as roughness.

phil

-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]]
Sent: Tuesday, May 23, 2000 8:56 AM
To: [log in to unmask]
Subject: [TN] Plated thru holes for compliant pins


Are there any special considerations for hole and hole wall plating
for compliant pin use?  I have been looking through 2221 and 2222,
but have found none.

Susan Mansilla
Robisan Lab

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################