DESIGNERCOUNCIL Archives

May 2000

DesignerCouncil@IPC.ORG
Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
Re: Test point size
From:
AMC-CAL-DVP Richard Hatano <[log in to unmask]>
Reply To:
DesignerCouncil E-Mail Forum.
Date:
Wed, 3 May 2000 09:55:58 -0700
Content-Type:
text/plain
Parts/Attachments:
text/plain (28 lines) 
I've been using .035" dia test points, and this is fine with the 3-4 test
houses I've encountered.  This is for boards that go about 20k/yr.  They
also want .100" center-to-center spacing min, a .125" clearance from board
edge, and another clearance that I don't remember at this time from taller
components.
Richard

> -----Original Message-----
> From: Mark Mainland [SMTP:[log in to unmask]]
> Sent: Wednesday, May 03, 2000 7:00 AM
> To:   [log in to unmask]
> Subject:      [DC] Test point size
>
> I'm trying to find out if anybody out there has been using test points
> smaller than .040" in dia. with good results?
>
> Thanks
>
> Mark Mainland
> PCB Designer
> Cherry Electrical Products
> 11200 - 88th Ave.
> PO Box 581913
> Pleasant Prairie, WI 53158
> Ph. 262.942.6659
> Page. 888.819.0198
> Fx. 262-942-6334

ATOM RSS1 RSS2