Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 31 May 2000 11:59:28 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In a message dated 05/31/2000 10:08:45 AM US Eastern Standard Time,
[log in to unmask] writes:
>
> I would like to know is there any way to measure the flux
> residue that left on the board, after wave-soldering process.
>
Poh,
There are several ways to go about it. Rather than go through a long
dissertation here, you can find much of the information on residue detection
methods in IPC-Handbook-001, section 8. This handbook is the companion to
J-STD-001. I served as editor for that section, so if you have some
questions after reading the material, I would be happy to try and answer them.
Doug Pauls
Technical Director
Contamination Studies Labs.
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|