Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 19 May 2000 17:59:35 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Many times the inner-layer pads for component mounting holes can be
smaller; the reason for having larger pads on the outer layers is to allow
for a proper solder fillet to form around the component lead.
The IPC has guidelines that can be used to determine the minimum diameter
for internal layer pads. Use the formula and table of IPC-2221, section
9.1 (pages 70-72) to determine the correct size. Be sure and use the
Minimum Internal Supported Annular Ring dimension for your calculations
(Table 9-2). Also note that for inner layers, you MUST use the maximum
drill size, not maximum plated hole diameter, for the calculations.
You're welcome.
Roger M. Stoops, PCB Designer
Spectra Precision Inc. Ph: 937.233.8921
5475 Kellenburger Rd. 937.233.4574 ext
Dayton, OH 45424-1099 288
USA Fax: 937.233.7511
Member IPC
Designer's Council,
C.I.D.
Denis Seguin
<dseguin@PARA To: [log in to unmask]
DOX.CA> cc:
Sent by: Subject: [TN] Padstacks info for multi layer
TechNet
<[log in to unmask]
ORG>
05/19/00
01:27 PM
Please
respond to
"TechNet
E-Mail
Forum.";
Please
respond to
Denis Seguin
Hi,
Since I`m new at this...
I would require some informations concerning the padstacks on multi-layer
board.
what should be the dimensions of the pads of a through hole component, on
the inner layers compared to the ones on the external layers of the board?
Should they be bigger or smaller (by how much?) or the same size?
I belive smaller but I'm not sure.
Thank You.
Denis Seguin
CAD Department.
P A R A D O X
S E C U R I T Y S Y S T E M S
Email: [log in to unmask]
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|