Technetters

Has anyone had any experience  - either good or bad, with solderpasting and
reflowing of RIST 2.5 (or smilar) edge connectors?

The reason I ask is that our designers have designed a single sided PCB for
Reflow soldering. From a cost point of view they would prefer an OSP finish
to HASL therefore we must provide a soldered finish to the edge connectors
with solderpaste.

Before I begin to organise trials I would appreciate hearing from any of you
who may have un/successfully gone down this path.

best regards

Thornton White

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################