Hi all,

we use some 15pin SMD FLZ connectors for flat cable.

I have the standard for the SMD PCB landing pads, but not for the stencil
openings. It's not defined in IPC-7525 - does someone has a standard.

BTW, testing the PCB through the flat cable FLZ port is a pain in the ****.
Is there any method to test through the FLZ connector but not using the cable?

The cable lifetime is only about 50 tests or so and it takes ages to fiddle
the cable into the connector.

Any shortcut?

regards

Jens

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################