Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 6 Apr 2000 13:11:34 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Lou,
I have done this in the past, but never on a midplane; only pinsavers and
gender-benders. I did a microsection to prove
the contact and assembly, but after that I didn't have a way to
inspect. We did do electrical test since they were 1:1,
so I guess that is an option for you as it sounds like the barrel is the
same.
I can only tell you it does work. Sorry about not having a good inspection
solution other the test.
Good Luck........DT
At 01:55 PM 4/6/00 -0400, you wrote:
>TechNetters, please comment. A colleague in design came to me with a
>proposal to make a mid-plane, as opposed to a backplane, board. It will
>have connectors press fitted from both sides. The problem is the
>connectors on both sides will go into the same holes. The connector tails
>are 0.11 inches long (whatever that is in mm) and the board is 0.25 inches
>thick (6.4 mm, if I recall). So there will be a little space between the
>tail ends when the connectors are pressed in from each side.
>
>The question is, what quality considerations arise here? How do we
>inspect these boards? A-610 has some criteria for press fit pins, but
>they apply to pins that go all the way through the board.
>
>Thanks for any comments...Lou Hart
>Quality Assurance, Compunetix
>
>##############################################################
>TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
>##############################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with
>following text in
>the body:
>To subscribe: SUBSCRIBE TECHNET <your full name>
>To unsubscribe: SIGNOFF TECHNET
>##############################################################
>Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
>information.
>If you need assistance - contact Keach Sasamori at [log in to unmask] or
>847-509-9700 ext.5315
>##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|