Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 27 Apr 2000 09:11:02 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Craig,
See IPC-A-610B Rev B, Section 4.2.1, 'Exposed Basis Metal'. There is
a note that addresses OSP and exposed copper. Even without applying the
note, it is still considered only a process indicator rather than a
nonconforming defect.
If you are already working to the new release of IPC-A-610C, it is
covered in better detail in Section 6.5.2, 'Exposed Basis Metal'.
Mike McMonagle
PCBA Process Engineering
Telxon Corporation
(713) 307-2443 Phone
(713) 307-2581 Fax
www.telxon.com
' Innovative Solutions for
Mobile Information and
Wireless Communications'
-----Original Message-----
From: Craig Leppanen [mailto:[log in to unmask]]
Sent: Thursday, April 27, 2000 7:47 AM
To: [log in to unmask]
Subject: [TN] spec for exposed copper
All-
I have a situation on an SMT OSP board. There is some exposed copper on the
periphery of fine pitch lands. The lands have greater than 85% solder
coverage
and acceptable joints. But the customer is concerned about the exposed
copper.
I have not seen a spec explicitly stating that exposed copper on an OSP
board is
acceptable. Does such a spec exist??
Thanks, Craig Leppanen
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|