Content-Type: |
text/plain; charset=us-ascii |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 13 Apr 2000 12:31:54 -0700 |
MIME-Version: |
1.0 |
X-cc: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
Folks,
Looking for info on Berg Pins regarding a condition
that is not typically seen in manufacturing, but may
arise in rework. IPC 610, in Chapt 6 addresses these
pins and solder condition / height on pins. If solder
happens to run up the pins and you decide to rework
them by stripping the solder then re[plating with
gold, is there a restricition against the replated
gold getting on the solder filet or pads?
=====
Bill Butman
Circuit Technology Center
45 Research Drive
Haverhill, MA 01832
__________________________________________________
Do You Yahoo!?
Send online invitations with Yahoo! Invites.
http://invites.yahoo.com
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|